Secure the crankshaft position

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Adjustment Tool 9995451

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the adjustment tool

Applies to turbo engines: Pull forward the charge-air pipe.
Remove the starter motor's mounting screws, 3 pcs.
Place the starter motor to one side.
Remove the blind cover plug and the sealing washer.
Turn the crankshaft clockwise slightly to avoid the adjustment tool being in the wrong position.
Install adjustment tool 9995451 .
Make sure that it bottoms out against the engine block.
Turn the crankshaft counter-clockwise until it stops against the drift.

NOTE: Check that the marking on the crankshaft's timing belt pulley matches the marking on the oil pump.