Install timing gear pulleys and timing belt

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Camshaft Belt Routing

GLL100850

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the timing gear pulleys with two screws so that they precisely act on the pulleys.
Then install the belt in the following order:
1. Idler pulley.
2. Intake cam pulley.
3. Exhaust cam pulley.
4. Water pump.
5. Belt tensioner.
Tighten center screw on the camshaft belt tensioner
to 5 Nm (3.7 lb.ft).

Then install the belt in the following order:
1. Idler pulley.
2. Intake cam pulley.
3. Exhaust cam pulley.
4. Water pump.
5. Belt tensioner.
Install new camshaft belt over crankshaft pulley wheel.
Then install the belt in the following order:
1. Idler pulley.
2. Intake cam pulley.
3. Exhaust cam pulley.
4. Water pump.
5. Belt tensioner.

NOTE: Adjust timing gear pulleys so that the screws are not at the limit positions in any of the oval holes.