Install camshaft adjustment tool

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Adjustment Tool 9995451

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove starter motor mounting screws (x3).
Place starter motor to one side.
Remove blind cover plug.
Turn the crankshaft slightly clockwise.
Install camshaft adjustment tool 9995451 .
Ensure that it reaches down as far as the cylinder block.
Carefully turn crankshaft counter-clockwise as far as it will go against the camshaft adjustment tool.
Check that the marking on the crankshaft timing gear pulley corresponds with the marking on the oil pump.