Reinstalling intake manifold: Install:
WARNING: This page is about a different variant/trim than selected.
- New gasket and the four lower intake manifold bolts.
- 1995 year model: Crankcase ventilation hose to intake manifold at servo pump.
- All: Intake manifold.
NOTE:
Do not pinch the crankcase ventilation hose between the cylinder head and intake manifold.
- Reinstall the EGR valve on the pipe. Tighten the EGR valve coupling to 50 Nm (37 ft lbs) .
- Upper intake manifold screws and tighten all bolts to 20 Nm (14.8 ft lbs) .
- Intake manifold support bracket screw.
- Dipstick.