Installing the flywheel

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Flywheel And Gear Sector 9995112

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Check that the contact surfaces on the crankshaft and the flywheel are totally clean.

Fit the flywheel.

There are different distances between the screw holes which means that the flywheel only fits in one way.

Use new screws.

Fit the gear sector 9995112

Fit the gear sector 9995112 .

Tighten the screws crosswise to 60 Nm . Following which, angle tighten all screws crosswise 90°.

Remove the counterhold 9995112