Installing components

Install: 

• the front timing belt cover.
• the torque rod bracket
• the cover over the ignition coils
• the upper timing belt cover
• the auxiliaries belt
• the expansion tank
• the servo reservoir. Check that the hoses are correctly positioned
• the starter motor. Tighten the screws at the gearbox to 40 Nm  . Tighten the support bracket screw to 25 Nm 
• the charge air pipe between the throttle body (TB) and the charge air cooler (CAC).

Fig 1: Identifying Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the trigger wheel
• the camshaft position (CMP) sensor housing and a new cover
• the intake air hose between the turbocharger (TC) and the air cleaner (ACL) cover
• the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for motor bracket
• the negative battery cable. First read Battery, disconnecting .

Fig 1: Identifying Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install: 

• the trigger wheel
• the camshaft position (CMP) sensor housing and a new cover
• the torque rod bracket. Tighten
• the cover over the ignition coils
• the charge air pipe over the engine. Remove the seals
• the air cleaner (ACL) cover and the intake air hose
• the engine stabilizer brace. Tighten the screws at the suspension turrets and the screw for motor bracket

Check the engine compartment. Wipe the engine compartment clean.