Checking Component And Cables
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Check engine coolant temperature sensor resistance. For resistance values, see Component Resistance Values .
Remedy as necessary.
Other information:
- To access/replace Coolant temperature sensor, see Replacing Overheat Protection, Thermostat Flame Sensor And Coolant Temperature Sensor .
- For other values, see Signal Specification Additional Heater 912-D/B .
- Continue
Refer to Verification
Check fuel pump (FP) and control module connector for contact resistance and oxidation according to Contact Resistance And Oxidation .
Check cable between control module #13 and fuel pump (FP) terminal 1 for an intermittent open-circuit according to Open-Circuit, Intermittent Faults .
Check cable between control module #11 and fuel pump (FP) terminal 2 for an intermittent open-circuit according to Open-Circuit, Intermittent Faults .
NOTE:
Diagnostic trouble code (DTC) HEA-815 Combustion fan signal and/or diagnostic trouble code (DTC) HEA-822 water pump signal is stored if there is a fault in the power cable.
Remedy as necessary.
Other information:
- To access the control module/connect breakout box, see Connecting the Breakout Box .
- To access/replace the fuel pump (FP), see Replacing Fuel Pump .
- To access/replace the overheat protection thermostat, see Replacing Overheat Protection, Thermostat Flame Sensor And Coolant Temperature Sensor .
- Continue
Refer to Verification