Checking Components And Cables
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Check cable between ECC control module #A10 and damper motor terminal 5 and ECC control module #A11 and damper motor terminal 4 (for right-hand drive car, control module #A8 and damper motor terminal 5 and control module #A9 and damper motor terminal 4) for an open-circuit according to Open-Circuit, Permanent Faults and a short-circuit to ground according to Short-Circuit To Ground, Permanent Faults and a short-circuit to supply voltage according to Short-Circuit To Supply Voltage. Permanent Faults .
If cables are OK, try a new damper motor.
Remedy as necessary.
Other information:
- To access/replace passenger side temperature damper motor, see Replacing Damper Motor Temperature Passenger Side .
- To connect the breakout box, see Connection Of Breakout Box ECC .
- Voltage on cables should be less than 1 V or 2-4 V below battery voltage, depending on which direction the motor is turning in. When the damper motor is not activated the voltage should be approximately 0 V. For other values, see Signal Specification ECC .
- Continue