Checking the Air Conditioning (A/C) System Function And For Noise: Verification
HINT: After the repair it is necessary to check that the fault has been found and corrected.
HINT: Carry out the following:
- Ignition off.
- Reinstall connectors, components etc.
- Connect the filling point's low pressure side (blue hose) to the service valve.
- Start the engine and allow it to run at 1500-1600 RPM.
- Place blower fan switch in the lowest active manual position.
- Place air conditioning (A/C) switch to on.
- Place REC-switch to on.
Check that the compressor switches in and out within the specified values:
The compressor should switch on at 295-325 kPa.
The compressor should switch off at 150-170 kPa.
Does the compressor switch in and out within the specified values?
- YES
Refer to Verification, Continued
- NO
HINT: After the repair it is necessary to check that the fault has been found and corrected.
HINT: Carry out the following:
- Ignition off.
- Reinstall connectors, components etc.
- Connect the filling point's low pressure side (blue hose) to the service valve.
- Start the engine and allow it to run at 1500-1600 RPM.
- Place blower fan switch in the lowest active manual position.
- Place air conditioning (A/C) switch to on.
- Place REC-switch to on.
Check that the compressor switches in and out within the specified values:
The compressor should switch on at 295-325 kPa.
The compressor should switch off at 150-170 kPa.
Does the compressor switch in and out within the specified values?
- YES
Refer to Verification, Continued
- NO