Checking Components

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Check signal cable between ECC control module #A29 and damper motor terminal 3 for an open circuit according to Open-Circuit, Permanent Faults and a short-circuit to supply voltage according to Short-Circuit To Supply Voltage. Permanent Faults .

If cables are OK, try a new damper motor.

Corrective action as necessary.

Other information:

To access/replace recirculation damper motor, see Replacing Damper Motor Recirculation .
To connect the breakout box, see Connection Of Breakout Box ECC .
The voltage on the signal cable varies between approximately 0-5 V depending on the damper motor position. The power supply to the damper motor should be approximately 5 V. For other values, see Signal Specification ECC .

Fig 1: Identifying 6-Pin Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Climate Control Module Connectors Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Self-Adjustment Of The Shutter Motor End Position