Checking Cables
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Check ECC control module connector for contact resistance and oxidation according to Contact Resistance And Oxidation .
If diagnostic trouble codes (DTC)s ECC-211, ECC-222, ECC-231 and ECC-235 are stored:
Check the common power supply cable between ECC control module #A7 and damper motor terminal 2 for a short-circuit to supply voltage according to Short-Circuit To Supply Voltage. Permanent Faults .
If, in addition, diagnostic trouble code (DTC) ECC-122 is stored:
Check the common ground lead between ECC control module #A22 and damper motor terminal 1 and outside temperature sensor terminal 4 for an open-circuit according to Open-Circuit, Permanent Faults .
Remedy as necessary.
Other information
- To disconnect the control module, see Replacing ECC Control Module .
- To access the passenger side temperature damper motor, see Replacing Damper Motor Temperature Passenger Side .
- To access the driver's side temperature damper motor, see Replacing Damper Motor Temperature Driver's Side .
- To access the air distribution damper motor, see Replacing Damper Motor Air Distribution .
- To access the recirculation damper motor, see Replacing Damper Motor Recirculation .
- To access the outside temperature sensor, see Replacing Outside Temperature Sensor (Electronic Climate Control)
- To connect the breakout box, see Connection Of Breakout Box ECC .
- The power supply to the damper motors should be approximately 5 V. For other values, see Signal Specification ECC .
- Continue
Refer to Verification