Starting fuel pump (FP)

WARNING: This page is about a different car, the 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition Switch ON Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove central electrical unit cover.
Remove fuel pump relay (position 103 in electrical distribution unit).
Connect a cable between relay base terminals 1 and 3.
- Ignition on.
Fig 2: Identifying Fuel Pump Relay Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fuel pump (FP) should operate.

Continue
Refer to Measuring line pressure

Fig 1: Identifying Ignition Switch ON Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove central electrical unit cover.
Remove fuel pump relay (position 103 in electrical distribution unit).
Connect a cable between relay base terminals 1 and 3.
- Ignition on.
Fig 2: Identifying Fuel Pump Relay Terminals
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fuel pump (FP) should operate.

Continue
Refer to Measuring line pressure