Installing front suspension components

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Line/ABS Cable Bracket, Wheel Arch Liner Plastic Nuts & Torx Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the bracket for the brake line / ABS cable (both sides)
the ABS sensor in the stub axle. Clean the sensor with a soft brush.

NOTE:

Ensure that the sensor seat is absolutely clean.

Tighten the sensor to 10 Nm .

Install the plastic nut (both sides).

Rivet the fender liner into place.