Installing the gear-shift position sensor, continued

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gear Selector Cable

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the cable duct on the stud on the gear-shift position sensor. Tighten the nut. Tighten to 25 Nm
the lever on the gear shift linkage rod. Tighten to 16 Nm
the transmission cable on the lever on the bracket for the cable on the transmission. Tighten to 25 Nm .