Fitting the control system casing

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Control System Cover, Harness Clamp, Cooler Return Line And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fit the control system casing on the transmission. Tighten the bolts alternately to 12 Nm . Torx TX 40.

Run the lead to the oil temperature sensor.

Fit:

the oil pipe to the transmission using a new O-ring
the return line to the control system casing
the cable harness to the retainer on the casing
the ground cable to the transmission.