Installing the screws and nuts for the steering gear and the sub-frame

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Engine Mounting Subframe Bolts

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

5 new nuts on the steering gear. Tighten to 50 Nm
the nut for the crash guard / sub-frame (A) (right-hand drive cars only). Tighten to 50 Nm
the screw for the sub-frame - front engine mounting. Then tighten the screws for the front and rear engine mountings. Tighten to 50 Nm .