Installing the drive shaft on the hub
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Link For Anti-Roll Bar, Tie Rod From Wheel Spindle, Screw For Brake Pipe Bracket, Screw For Drive Shaft
Use holder 9995563 to hold the control arm down.
Fold out the spring strut and locate the drive shaft in the hub.
Install the drive shaft screw by hand. Use a new screw.
Remove the holder.
NOTE:
Take care not to damage the drive shaft boot.