Installing the anti-roll bar screws

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Anti-Roll Bar

Courtesy of VOLVO CARS OF NORTH AMERICA.

Right-hand drive models only:

Raise the sub-frame approximately 100 mm from the body. Locate the steering gear and collision protection in the sub-frame. Install the anti-roll bar screws on the left-hand side. Tighten both bearing caps.

Tighten to:50 Nm .