Check, connectors and cable
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Check the RTI control module and back-up (reversing) light switch (cars with automatic transmission: gear-shift position sensor) connectors for contact resistance and oxidation according to Contact resistance and oxidation .
check cable between the control module #B11 and back-up (reversing) light switch terminal 2 (for cars with automatic transmission: gear-shift position sensor terminal 5) for an open-circuit according to. Open-circuit, permanent faults , a short-circuit to ground according to Short-circuit to ground, permanent faults , and a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .
Remedy as necessary.
Other information:
- To access/replace the control module, see Replacing the control module, old system .
- To access/replace the back-up (reversing) lamp switch, see Replacing bulb in automatic transmission position indicator .
- To access/replace the gear-shift position sensor, see Gear-shift position sensor, replacing .
- To connect the breakout box, see Connecting the breakout box .
- Continue
Refer to Verification