Checking signal cable resistance to ground

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Wait for approximately 150 seconds (cars with immobilizer 245 seconds).
Camshaft position (CMP) sensor disconnected.
Connect an ohmmeter between the camshaft position (CMP) sensor connector terminal 2 (engine control module (ECM) side) and ground.

Fig 3: Identifying 3-Bit Connector
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Ohmmeter
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is resistance infinite?

YES
Refer to Checking control module connector
NO
Refer to Checking for a short-circuit