Connecting the breakout box

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

The control module power supply must be disconnected when connecting or disconnecting the breakout box, otherwise it may be damaged.

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Control Module Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

For more help with connection see Measuring instruments .
Ignition off
Disconnect the transmission control module (TCM).
Connect adapter 9813195 to transmission control module (TCM) connector and connect breakout box 9813190 to adapter.
NOTE:
Ensure that the adaptor is the right way round - with the breakout box cable harness outwards towards the fender.

Fig 3: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Control Modules
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Checking ground terminals

CAUTION:

The control module power supply must be disconnected when connecting or disconnecting the breakout box, otherwise it may be damaged.

Fig 1: Identifying Ignition Switch OFF Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Control Module Disconnected

Courtesy of VOLVO CARS OF NORTH AMERICA.

For more help with connection see Measuring instruments .
Ignition off
Disconnect the transmission control module (TCM).
Connect adapter 9813195 to transmission control module (TCM) connector and connect breakout box 9813190 to adapter.
NOTE:
Ensure that the adaptor is the right way round - with the breakout box cable harness outwards towards the fender.

Fig 3: Identifying Breakout Box
Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 4: Identifying Control Modules
Courtesy of VOLVO CARS OF NORTH AMERICA.

Continue
Refer to Checking ground terminals