Installing the right control arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Screws For Control Arm

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the control arm. Use new screws
Tighten the front screws. Tighten to: Tightening torque . Use protractor 9512050
Tighten the rear screw and the nut. Tighten to: Tightening torque
Lower the engine
Remove the mobile jack
Tighten the screws on the right engine mounting. Tighten to 35 Nm . Angle-tighten 90° . Use new screws.

Applies only to cars with 6 cylinder engines:

Install the oscillation damper. Use new screws. Tighten according to: Tightening torque