Installing and tightening front end components (both sides)
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- one new M14 lock nut on each side of the ball joint pinion. Counterhold the ball joint pinion while tightening so that the boot cannot turn. Tighten
- one new M10 lock nut on each side of the anti-roll bar. Counterhold the ball joint pinion while tightening so that the boot cannot turn. Tighten. See Summary of tightening torques for specific components
Tighten the drive shaft screw. Counterhold using a screwdriver in the brake disc vents. Tighten. See Summary of tightening torques for specific components .
Install the soundproofing over the drive shaft (applies to certain versions).