Lowering the sub-frame at the rear edge

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Sub-Frame Screws, Brackets & Washers

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place a mobile jack with a universal fixture 9995972 at the rear of the subframe.

Remove the screws holding the sub-frame brackets to the bodywork on both sides.

Remove the rear sub-frame screws together with the brackets and washers.

Unscrew the front screws in the sub-frame by 10-15 mm.

Fig 2: Identifying Bracket And Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the bracket for the heated oxygen sensor (HO2S) from its mounting (6 cylinder engines only).

Lower the rear edge of the sub-frame approximately 90 mm. Ensure that the steering gear screws are released from the sub-frame.

Remove the mobile jack.