Removing the lifting tools

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Brake Servo Connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower the car.

Remove the lifting tools.

Install the engine cover (diesel engines only).

Applies to cars with speed related power steering:

Connect the connector at the brake servo (left-hand drive cars).

Connect the connector at the right-hand suspension turret (right-hand drive cars).

Fig 2: Topping Up Oil Level In Servo Reservoir

Courtesy of VOLVO CARS OF NORTH AMERICA.

Top up the oil level in the servo reservoir. Bleed the system.

For the correct oil quality, see specifications.

WARNING:

Avoid skin contact with the oil.

Repeatedly turn the steering wheel to full lock.

Top up the oil if necessary.

Lower the car.

Apply the hand brake.

Start the engine.

A: Turn the steering wheel slowly to the right. Hold on full lock for 2 seconds.

B: Turn the steering wheel slowly to the left. Hold on full lock for 2 seconds.

Repeat operations A and B approximately 10 times.