Checking the position of the track rod in the steering gear

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Length Of Track Rod In Relation To Steering Gear Housing

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that track rod is in the same position as when it was removed.

Fig 2: Identifying Screw For Joint Between Steering Gear And Steering Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lift in the steering gear in from the left (left-hand drive cars).

Lift in the steering gear in from the right (right-hand drive cars).

Allow the steering gear to rest on the sub-frame.

Install the oil pipes on the steering gear. Use new O-rings. Tighten to 25 Nm .

Secure the oil pipes in the holders on the power steering (left-hand drive).

Applies to cars with speed related power steering:

Slide the connector to the terminal at the brake servo.

Install the cabling in the clip along the ABS cable.

Applies to all models:

Fig 3: Locating Steering Shaft Joint On Steering Gear

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE:

Always check carefully that the ball joint's screw hole aligns with the cut-out in the steering gear shaft.

Align the steering shaft joint.

Lift up the rear edge of the sub-frame slightly using a mobile jack and universal fixture 9995972 .

Locate the steering shaft joint on the steering gear.

Install a new steering shaft screw. Tighten to 20 Nm .

Fig 4: Identifying Rear Engine Mounting Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the rear engine mounting screw.

Align the steering gear so that it is positioned straight relative to the sub-frame. Tighten the screw. Tighten to 50 Nm .