Remove the Constant Velocity Joint From the Shaft

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Constant Velocity Joint From Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tension the snap ring out of the groove.

Position the drift, modified as illustrated, between the wings of the snap ring. See Modifying the Drift .

Tap out the inner ring on the shaft so that the snap ring remains in open position.

Tap out the constant velocity joint. Use a brass drift.

NOTE: Only tap the inner ring. Take care not to damage the ball holder or outer ring.

Remove the snap ring from the joint.