Installing the Transmission
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Use the transmission fixture and the mobile jack to line up the transmission with the engine.
NOTE:
Ensure that the transmission comes straight in towards the engine without placing any stress on the center of the clutch driven plate.
Install the screws for the transmission/engine and the screw for the starter motor.
Tighten alternately until the transmission and the cylinder block are in contact all the way around. Torque tighten in the following order: M12 to 80 Nm . M8 to 25 Nm . Tighten the starter motor screws to 80 Nm .
Remove the transmission fixture and the mobile jack from the transmission.