Installing the Transmission/Engine And the Torque Control Arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Torque Control Arm/Torque Rod Screws And Transmission/Engine Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the 2 screws for the transmission/engine. Tighten to 80 Nm
the pipe for the crankcase ventilation loosely
the torque control arm. Use guide sleeves and new screws and nuts. Tighten the screws for the torque control arm to the transmission cover/engine. Tighten to 45 Nm + 90° . Tighten the screw for the torque control arm/torque rod. Tighten to 35 Nm + 90°
the screws for the crankcase ventilation pipe. Tighten to 25 Nm .

Tighten the nut for the rear engine pad. Tighten to 50 Nm .