Install the rear engine mounting on the transmission

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Mounting On Transmission Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the mounting on the transmission (3 screws). Tighten the two rear screws to 50 Nm . Remove the front screw again.

Install the cover. Use the screw for the mounting

Press up the cover against the mounting. Tighten the screw to 50 Nm .

Install the engine pad. Use a new nut

Fig 2: Identifying Steering Gear & Hook

Courtesy of VOLVO CARS OF NORTH AMERICA.

Align the engine pad locating pin in the cover. Install the nut loosely.

Install the screw in the engine pad and steering gear

Do not tighten the screw
Remove the support hook 9995045 .

Install:

The cable for the heated oxygen sensor (HO2S) to the cover. Use clamps
The connector and cable for the vehicle speed sensor (VSS).

Right-hand drive cars only:

Fig 3: Identifying Distance From Body

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the tape from the drive shaft. Let the shaft rest on the oil pipes.

Raise the sub-frame so that it is 100 mm from the bodywork. Locate the steering gear and collision protection in the sub-frame. Install the left bearing and cap for the anti-roll bar. Tighten both the bearing caps to 50 Nm .