Removing the Collision Protection System Over the Steering Gear

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Collision Protection System Locking Screw

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Applies only to right-hand drive cars .

Remove the locking screw and the nut for the collision protection system.

Leave the collision protection system in place on the steering gear.

Unhook the servo and the evaporator lines from the holders on the right-hand side of the sub-frame.

Also unhook the servo line from the clip on the sub-frame.