Installing the Engine Pad
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Align the engine pad's guide pin in the cover. Use new nut. Fit the nut lightly.
Install the screw for the steering gear engine pad
Do not tighten the screw.
Remove the support hook 9995045 .
Install:
- The heated oxygen sensor's cable with clamps in the cover
- The connector and cable to the speed sensor.
- Ground lead on the gearbox
Right-hand drive cars only
Remove the tape from the drive shaft and let the shaft rest on the oil pipe.
Raise the frame approximately 100 mm from the body.
Aligned the steering gear on the right-hand side and the collision protection system on the sub-frame. Fit the screws for the anti-roll bar's left-hand bearing with cap and tighten both bearing caps.
Torque: 50 Nm .