Installing the Left-Hand Drive Shaft To the Gearbox And the Wheel Spindle

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Constant Velocity Joint Housing At Transmission

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Check that the seal is fitted on the drive shaft.

Fit the drive shaft joint sealing ring in accordance with: Seal CV Joint Housing, Replacing .

Press the drive shaft joint in so that the lock ring engages its groove in the gearbox. Check by pulling in the joint housing.

Locate the drive shaft in the wheel hub. Install a new screw loosely in the drive shaft.

Fig 1: Constant Velocity Joint Housing At Transmission

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Check that the seal is fitted on the drive shaft.

Fit the drive shaft joint sealing ring in accordance with: Seal CV Joint Housing, Replacing .

Press the drive shaft joint in so that the lock ring engages its groove in the gearbox. Check by pulling in the joint housing.

Align the drive shaft in the wheel hub. Fit a new screw loosely in the drive shaft.