Installing the Angle Gear
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only applies to vehicles with four-wheel drive AWD
NOTE:
Before installing the angle gear the splined joint between the gearbox and the angle gear must be lubricated with grease in accordance with: Splines Greasing
.
Check that the contact surfaces on the gearbox and the angle gear are clean.
Fit the angle gear. Tighten the screws, M10, alternately to light contact. Tighten.
NOTE:
Only applies to vehicles with four-wheel drive AWD
NOTE:
Before installing the angle gear the splined joint between the gearbox and the angle gear must be lubricated with grease in accordance with: Splines Greasing
.
Check that the contact surfaces on the gearbox and the angle gear are clean.
Fit the angle gear. Tighten the screws, M10, alternately to light contact. Tighten.