Fitting the Subframe To the Body
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use new screws. Lubricate the screws' threads.
Applies to certain models.
Raise the subframe so that it remains approx. 150 mm before reaching the side member.
Secure the servo line with the rubber clamp in the front on the top of the frame. Fit the screw loosely.
NOTE:
When the subframe is raised, make sure that the spring strut ball joint pin aligns in the link arm.
Install:
- the new screws and the support bracket at the back
- the bracket screws loosely.
Tighten the subframe screws to light contact.
Remove the mobile jack.
NOTE:
Use new screws. Lubricate the screws' threads.
Applies to certain models.
Raise the subframe so that it remains approx. 150 mm before reaching the side member.
Secure the servo line with the rubber clamp in the front on the top of the frame. Fit the screw loosely.
NOTE:
When the subframe is raised, make sure that the spring strut ball joint pin aligns in the link arm.
Install:
- the new screws and the support bracket at the back
- the bracket screws loosely.
Tighten the subframe screws to light contact.
Remove the mobile jack.