Removing the gear cables from the levers and attachments on the gearbox
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Remove:
- cable conduit from the gearbox, 2 screws, 1 nut
Use jimmy bar 9997077 to detach the ball joint for the gear cable from the levers.
Detach the casing for the gearbox cables from the bracket in the gearbox by pressing the locking sleeve backwards.
Lift up the gearbox cables.
Tie up the gearbox cables.
Disconnect the connector from the reversing lamp switch.
Remove:
- the outer lever by knocking out the pin, move it over to the new gearbox
- the screws from the mechanical cable
- the bracket (from the gearbox).