Installing the subframe on the bodywork

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Sub-Frame And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Use new screws. Lubricate the screw threads.

Lift up the subframe until it is about 150 mm from the side member.

Secure the power steering pipe at the front edge of the upper side of the subframe using the rubber covered clamp. Install the screw. Finger tighten.

NOTE: When the subframe is raised, ensure that the screws for the steering gear locate in the frame. Ensure that the ball joint pinion for the spring strut is aligned in the control arm.

Install:

the new screws and the support bracket at the rear edge
the bracket screws loosely.

Tighten the subframe screws to light contact.

Remove the mobile jack.