Installing the bevel gear

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Angle Gear Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Only applies to vehicles with four-wheel drive AWD.

NOTE: Before installing the bevel gear, lubricate the spline joint between the transmission and the bevel gear using grease. See Splines greasing .

Check that the contact surfaces on the gearbox and the angle gear are clean.

Install the angle gear. Tighten the screws, M10, alternately to light contact. Tighten.