Installing the remaining screws for the gearbox and starter motor

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearbox Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the 4 x screws for the transmission/starter motor. Tighten to 50 Nm
the screws for the starter motor. Tighten to 50 Nm .

Fig 2: Ground Lead, Coolant Hose, Charge Air Pipe And Clamps

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the hose and the clamp for the charge air pipe which are under the engine
the ground lead mounting on the sub-frame
the engine coolant hose to the pipe at the rear of the engine.

Connect the vacuum hose to the rear engine pad and secure the hose to the gearbox using a tie strap.

Tighten the clamp for the servo line on the sub-frame.