Installing engine compartment components

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Engine Hoses

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the inner of the two hose couplings for the passenger compartment heater connecting sleeve in the bulkhead
the charge air pipe for the turbocharger (TC)
the hose between the intake manifold and charge air cooler (CAC)
the clamp for the cable harness on the engine.

Tighten the nut for the rear engine pad. Tighten to 50 Nm .

Fig 2: Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the air cleaner (ACL) housing assembly with the intake manifold and connections
the ground lead for the mounting on the engine (where applicable)
the upper torque rod between the wheel arches. Tighten the screws. Tighten to 50 Nm
the screw for the torque rod to engine mounting. Tighten to 80 Nm .

Fill with coolant. Carefully check while reaching operating temperature or test driving that the level remains the same and that there is no leakage.

Also see Transmission replacement, post-checking .