Install the right drive shaft in the transmission, the wheel spindle and the control arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Right-Hand Drive Shaft To Gearbox

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Take care not to damage the drive shaft seal in the transmission.

Install the drive shaft pilot bearing cover

Tighten with 25 Nm .

Locate the drive shaft in the wheel hub. Install the screw loosely in the drive shaft.

Install:

the mobile jack under the sub-frame. Remove both the sub-frame screws. Lower the sub-frame approximately 10 cm
the wheel spindle on the control arm
the lock nut loosely.

Lift the sub-frame to the bodywork. Install the new screws for the sub-frame.

Press the evaporator cable and the oil pipe into place in the sub-frame clips.