Installing the screws for the transmission and engine

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearbox Mounting Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Lower the vehicle

Remove the lifting beam from the engine.

Install:

the remaining screws for the transmission and starter motor
the 2 screws for the starter motor. Tighten
the screw for the ignition position sensor. Tighten.