Installing the screw for the front engine pad and the torque rod mounting in the transmission

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearbox Torque Rod Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the M10 screw for the front engine pad.
the torque rod mounting on the transmission.

NOTE: Use new screws . Tighten. See Tightening torque .

Applies only to cars with parking heaters

Install the heater in the bracket. Tighten the nuts. Secure the fuel line in the sub-frame.