Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Right-Hand Drive Shaft To Gearbox

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Take care not to damage the drive shaft seal in the transmission.

Install the pilot bearing cover for the drive shaft

Tighten.

Align the drive shaft in the wheel housing.

Install:

the screw loosely in the drive shaft.
the wheel spindle on the control arm
the lock nut loosely.

Press the evaporator cable and the oil pipe into place in the sub-frame clips.