Installing and tightening front suspension components
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
Tighten the drive shaft screw. Use a new screw. Counterhold using a crow bar in the brake disc. Tighten. See Tightening torque .
Install the nut for the anti-roll bar at the spring strut (left hand side only). Use a new lock nut .
NOTE:
Counterhold the ball joint pinion when tightening. This is so the ball joint boot does not turn.