Fitting the sub-frame to the body

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Sub-Frame And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

CAUTION: Use new screws (4 x M14). Lubricate the screw threads. Make sure that the screws for the steering gear locate in the sub-frame.

Start on the left-hand side.

Raise the subframe with the mobile jack 9985972 .

Locate the steering gear screws in the subframe.

Install the subframe and support bracket screws, start on the left-hand side followed by the right. Tighten as per Tightening torque .

Move the mobile jack to the right-hand side. Remove the existing screws and repeat the operation.