Installing the angle gear

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Only applies to vehicles with four-wheel drive AWD

Fig 1: Angle Gear Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Before installing the bevel gear, lubricate the spline joint between the transmission and the bevel gear using grease. See:

Check that the contact surfaces on the gearbox and the angle gear are clean.

Install the bevel gear. Use new screws. Tighten the screws alternately to light contact. See Tightening torque .