Fitting the sub-frame to the body

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Sub-Frame And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

NOTE: Use new screws. Lubricate the screw threads.

Applies to certain models.

Raise the sub-frame so that it remains approx. 150 mm before reaching the side member.

Secure the servo line with the rubber clamp in the front on the top of the frame. Fit the screw loosely.

NOTE: When the sub-frame is raised, make sure that the spring strut ball joint pin aligns in the link arm.

Install:

the new screws and the support bracket at the back
the bracket screws loosely.

Tighten the sub-frame screws to light contact.

Remove the mobile jack.