Fitting the remaining screws to the gearbox/starter motor

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cable Harness Clamp Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the screws, 3 x M10, to the gearbox/engine. Tighten
the screws for the starter motor. Tighten. See Summary of tightening torques for specific components
the bracket to the coolant hose-cable harness
the bracket to the cable harness clamp and the bracket for the heated oxygen sensor (HO2S) connectors in the rear edge of the gearbox
the clamp to the cable harness at the rear edge of the engine
the bracket for the air cleaner (ACL), 2 x M10. Tighten (Applies only to B5254T4).