Installing the transmission cable bracket on the transmission and the cable on the lever

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Cable At Lever And Cable Bracket Screws On Transmission

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten with 25 Nm .

Install:

the large connector. Lock it into place
the bracket with the oil pipe. Press the dip stick pipe into place in the transmission oil pipe
the two cable conduit nuts. Tighten to 10 Nm
the connector furthest in at the cable conduit
the oil pipe on the transmission. Tighten to 25 Nm .

CAUTION: Check that the transmission bleed hose/valve is not trapped. There is a risk of overpressure in the transmission.